MFC5100M Gas Mass Flow Controller

Thermal MEMS mass flow controller Touch screen for local setpoint Full scale 1 to 20 Ln/min Repeatability ±0.5% r.d. / ±0.1% f.s. M12 or DB9 electrical connector VCR 1/4” or BSPT 1/8” female port

MFC5000 Gas Mass Flow Controller

Thermal MEMS mass flow controller Full scale 2 to 20 SLPM DeviceNet, RS485 Modbus, analog output VCR or BSPT 1/8” to 1/2” female M12 and DB9 electrical connectors Max pressure loss 20 kPa at 20 SLPM

MFC4200 Gas Mass Flow Controller

Thermal MEMS mass flow controller Full scale from 10 mLn/min Ranges up to 1000 mLn/min Analog 0 ~ 5 Vdc, 4 ~ 20 mA or RS485 UNF 10-32 or 1/8” compression port Differential pressure 0.2 MPa

MFC2000 Gas Mass Flow Controller

Thermal MEMS mass flow controller Full scale 50 mLn/min to 200 Ln/min Largest span in the MFC series Analog 0 ~ 5 Vdc, 4 ~ 20 mA or RS485 Control pressure 0.1 ~ 0.8 MPa 7/16-20UNF to VCR 1/2” connections

MFC1600 Gas Mass Flow Controller

Thermal MEMS mass flow controller Full scale 50 mLn/min to 100 Ln/min Accuracy ±1.5% r.d. over 20 ~ 100% FS Control pressure 0.1 ~ 0.8 MPa Analog 0 ~ 5 Vdc or RS485 setpoint G 1/4” ~ 3/8” or quick-twist fitting

MFC4000 Gas Mass Flow Controller

MEMS thermal mass flow controller
Full scale 50 to 500 mLn/min
Turn-down ratio 100:1
Normally closed control valve
UNF 10-32 female connection
45 x 45.5 x 20 mm body

Gas Mass Flow Controllers — closed-loop gas delivery

A mass flow controller measures the flow and drives a valve to hold the setpoint, so the delivered mass flow stays stable when upstream pressure or downstream restriction changes. These units are used where a gas flow has to be held rather than only observed: gas mixing, test benches, analysers and process lines.

Selection depends on the full-scale range, the gas, the required control response, the maximum working pressure and the interface used to set the setpoint. Each product page shows the manufacturer’s technical data in a readable table, and the datasheet carries the full specification, dimensions and ordering information. If the task only needs a measurement, a mass flow sensor or meter is the simpler choice; a controller is the option when the flow itself must be regulated.